Windows 8 - local account
https://www.youtube.com/watch?v=kF4_4W6MVwA
Nabootovat z instalačky W8
Vybrat jazyk ... NEXT
Opravit systém (repair .... )
TROUBLE shoot
Rozšířené (advanced ...)
Commandprompt
Najít disk, na kterém jsou windows, ve složce USERS se podívat na loginname uživatele.
cd windows\system32
ren utilman.exe utilman2.exe
ren (COPY) cme.exe utilman.exe
exit, reboot ...
Potom při kliku na usnadnění přístupu se spustí cmd.exe
net user <loginname> *
vyžádá si zadání 2x nového hesla (2x enter - bez hesla)
exit >> kik na uživatele a jste tam ...
To reset a forgotten administrator password, follow these steps:
Boot from Windows PE or Windows RE and access the command prompt.
Find the drive letter of the partition where Windows is installed. In Vista and Windows XP, it is usually C:, in Windows 7, it is D: in most cases because the first partition contains Startup Repair. To find the drive letter, type C: (or D:, respectively) and search for the Windows folder. Note that Windows PE (RE) usually resides on X:.
Type the following command (replace “c:” with the correct drive letter if Windows is not located on C:):
copy c:\windows\system32\sethc.exe c:\
This creates a copy of sethc.exe to restore later.
Type this command to replace sethc.exe with cmd.exe:
copy /y c:\windows\system32\cmd.exe c:\windows\system32\sethc.exe
Reboot your computer and start the Windows installation where you forgot the administrator password.
After you see the logon screen, press the SHIFT key five times.
You should see a command prompt where you can enter the following command to reset the Windows password (see screenshot above):
net user your_user_name new_password
If you don’t know your user name, just type net user to list the available user names.
You can now log on with the new password.
http://4sysops.com/archives/forgot-the- ... eys-trick/
Tamim answered 3 years ago
If you have forgotten what your administrator password is, you will need to reset the password in order to properly log into your computer.
1 Insert your current Windows CD into your computer's CD-ROM drive.
2 Press any key to start booting Windows from the CD when a separate screen opens asking you to do so.
3 Press "Enter" on your keyboard to set up Windows when the Welcome screen opens.
4 Check the box next to "I Accept" at the bottom of the Licensing Agreement screen. You can also hit "F8" to accept it, as well.
5 Select your Windows installation, and press "R" to repair Windows when the "Setup/Repair" screen opens.
6 Allow your computer to run the repair, which may take several minutes. When the "Repair" and "Copying Files" actions are complete, your computer will automatically reboot itself.
7 Press "Shift" and "F10" when your computer boots back up and you see an "Installing Devices" progress bar at the bottom left-hand side of the screen.
8 Type "NUSRMGR.CPL" in the prompt box, then press "Enter."
9 Click on the Admin account and reset the password.
10 Exit the command box, and allow your computer to finish the repair.
Regards,
Tamim
https://uk.answers.yahoo.com/question/i ... 511AArhdUo